2 mm TDC Grooving Holder suitable to Taegutec Insert 2 mm pack of 1 Size:2525 Shank Right Hand T-Max-15 mm durability

durability

SPMG DRILLING INSERTS

ER16 series collets are available in sizes from 1 mm to 10 mm

taper and roundness• Steel body and interchangeable carbide anvils• Extension rods and washers for fine adjustment in sizes to select a specific range• Dial indicator fully protected by a rugged cover

All critical tool holder surfaces are precision-groundRear thread for pull stud is M12X 1

2 mm TDC Grooving Holder suitable to Taegutec Insert 2 mm pack of 1 Size:2525 Shank Right Hand T-Max-15 mm durability2 mm TDC Grooving Holder suitable for Taegutec Insert 2 mm LEFT RIGHT HAND Grooving holders are used for parting and grooving in the turning machine. 2 mm grooving holder suitable for the Taegutech insert profile. It can fit any insert naming TDC, TDJ, TDT 2 mm T max is the maximum grooving capacity of the holder. If the grooving capacity is 16 mm, it means it can part off 32 mm of the round bar.