Power-Tec Pinza Clamp - 50mm 91095 Lathes buffing on copper

buffing on copper

Typical Measuring Tolerance: ± 1

ideal for use on both tight and awkward release buttons or on connectors in hard to reach areas

The battery is more fully charged than using traditional relay systems and any voltage losses in cabling are reduced

whilst rolling up for compact storage when not in use

Power-Tec Pinza Clamp - 50mm 91095 Lathes buffing on copperDeep throat and wide jaws allow this clamp to get over flanges and deep onto the panel for a sure, non slip grip. 50mm wide jaw. 45mm deep throat, making it ideal for fitting over flanges. 2 tonne pull capacity at right angle. 6 tonne pull capacity in line.