AXLETECH DRIVESHAFT ADAPTER, 1710 CROSS CUT STRAP Solenoids and Manifold are all

Solenoids and Manifold are all made by Parker

0 oz/yd² (170 g/m²))

* Note these are installed and held in place with a press fit and can be removed by pounding them out with a long drift from the other side of the axle tube or with a blind hole puller and slide hammer

These are the newer versions and do not have the sprag bearings that are prone to failure

This Kit does require some clearance of the mount blocks for the ram

AXLETECH DRIVESHAFT ADAPTER, 1710 CROSS CUT STRAP Solenoids and Manifold are allThis 1710 yoke will bolt directly to any narrow Axletech 4000 or T 600 transfer case with the cross cut pattern yokes, allowing you to easily adapt a common 1710 5 Ton surplus drive shaft to your driveline! No need for an adapter between your pinion yoke and U joint flange adapter!