Infrared Emitter Module cable1 you would get 1600 steps/rev

you would get 1600 steps/rev using EasyDriver

CMOS compatible outputs

IR receivers are little diodes with a photocell that are tuned to detect to infrared light

Power Supply: 12V - 3A

3V) GND Ground SCK SPI Clock MISO SPI Data Output MOSI SPI Data Input NSS Chip Select RESET Reset Control DIO0 Interrupt (Tx/Rx Done)

Infrared Emitter Module cable1 you would get 1600 steps/revDo you want to control your Arduino with an IR remote? Do you want to use your Arduino to control your stereo or other devices?. The Infrared Emitter is used to transmit infrared signals through an infrared LED, while there is an Infrared receiver to get the signals on the other side . An infrared LED is like any other LED, with its color centered around 940nm. We can use the emitter not only to transmit data or commands, but also to emulate remotes