SOP16 DIP Adapter Converter PCB Board 0.65/1.27mm Programmer Testing Clip 1x 5V/800mA Switch Power Supply

1x 5V/800mA Switch Power Supply Module

To use the 8 position DIP switch you just need to solder the pins on your PCB use a DIP holder and use this as a simple ON/OFF switch of the line in which the switch is connected

Maximum switching: 300 operating/minute (mechanically)

maze solvers

you can connect Control Input Pin to any GPIO pin of 5V operating Arduino like UNO or MEGA and control the relay by your program

SOP16 DIP Adapter Converter PCB Board 0.65/1.27mm Programmer Testing Clip 1x 5V/800mA Switch Power SupplyWhen we develop a system, we go from concept to design to prototype to testing and then final product and in all of these prototyping and testing is the most important step as it irons out any flaws in your concept and remove the bugs. We do not make PCBs for testing purpose instead we use breadboard and breakout boards for the same. If we use QFP32 SOP16 SOP128 SMD package which require PCB soldering to work, it will be a problem while prototyping