Sensor Arm Photocell for Beogram 4000, 4002, and 4004 Solid wood (original frames are

Solid wood (original frames are veneer on particle board)

tracking will not work properly

110V North American version

Some experience with electronics is helpful

Power cable

Sensor Arm Photocell for Beogram 4000, 4002, and 4004 Solid wood (original frames areReplaces original sensor arm photocell in Beogram 4000, 4002, and 4004. Direct drop in replacement for original B&O part 8760002. Most likely fix if Beogram drops the arm on an empty rotating platter. This post discusses installation in a Beogram 4000 (4002 4004 have the exact same setup). Photo voltage: ~0. 45V Installation requires soldering desoldering capability. Test the sensor signal with an oscilloscope before using the Beogram after