1/2X4X96FSB Bucket Pin It is 5 mm thick

It is 5 mm thick with an OD of 160 mm

A bucket pin shim will work just fine if it is a little larger than the Outer Diameter of your pin but not if it is smaller (it has to fit around the pin)

This bolt on Cutting Edge has an industry standard part number of 8E4567 and has 3 bolt holes

This bolt on side cutter (can be welded on) is designed for mini-excavator buckets and has an industry standard part number 20s-70-71330 also known as MSC-R

This bucket ear boss is machined to accept a 50mm bucket pin

1/2X4X96FSB Bucket Pin It is 5 mm thick1 2" x 4" x 96" Flat single bevel, weld on cutting edge. Good to weld under the front edge of your bucket to give it a wear surface or to replace the front lip of your bucket. If it becomes the new front lip of your bucket you can drill or blow holes in it to match a bolt on edge if you like.