Pay in 4 interest-free payments of $22.25 Learn more
Ships within 48 hours · Estimated delivery Aug 11 - Aug 16
The programming tool required to flash the MaxxECU 8HP (GEN1) CAN control support
5x1m brown 1
PN: 0258 007 057
The connector required/used for the MaxxECU PWM 2 Stepper Idle Module
127mm outside diameter
Ignition Module - 3 output PNP The programming tool required toIgnition module with 3 separate ignition outputs, for adapting logic level MaxxECU and similar ignition outputs to drive dumb coils. Don't forget: 7 pin JPT Connector Pinout: 1: IGN1 OUT 2: IGN1 IN 3: IGN3 OUT 4: GND 5: IGN3 IN 6: IGN2 OUT 7: IGN2 IN Note: Hueco module is sent but functionally identical to Bosch unit.
US$ 59.95
US$ 12.95
US$ 64.95
US$ 69.95
US$ 84.95
US$ 34.95
US$ 22.90
US$ 104.95
US$ 89.95
US$ 72.90
US$ 97.90
US$ 24.95
US$ 84.95
US$ 17.95
US$ 104.95
US$ 16.95
