BuildTak - 406 mm x 406 mm (16.0" x 16.0") screw Push the replacement tip in

Push the replacement tip in fully and tighten the locking nut

The manufacturer achieved good results were achieved using standard PLA parameters and standard build surface preparation (blue tape or glue stick)

The original is still the best

Supports keep printing and saving on power outage

Requirements

BuildTak - 406 mm x 406 mm (16.0" x 16.0") screw Push the replacement tip inIdeal build surface for FFF 3D printers. Key Features: Works with ABS, PLA, HIPS, PET+, Brick, Wood & Flexible (TPE) filaments; additionally we have had success with getting nylon and t glase (PETT) to adhere when used with a thin layer of washable glue stick on the BuildTak surface Installs much easier than masking tape or films typically used and with fewer chances of air bubbles Protects build plate Heat resistant and durable, can be reused for