TURN SIGNAL SWITCH (READ DESCRIPTION) JD1050 3GM series including the 1GM10

3GM series including the 1GM10

Covers the entire Yanmar 2T90 engine

Remove the injector hold down and remove the hold down studs by tightening two nuts against each other on the stud and then using the lower nut to unscrew the stud

This is the little seal that seals the filter screen to the inlet tube

Get attention when you need it with this very loud replacement horn

TURN SIGNAL SWITCH (READ DESCRIPTION) JD1050 3GM series including the 1GM10TURN SIGNAL SWITCH (READ DESCRIPTION) Shop Notes: This is a relatively universal turn signal switch that can be used in place of discontinued Yanmar turn signal switches. The switch has 3 positions (off Left Right and has 6 terminals but Yanmar will only use 3 of those terminals (IN Left? Right). The switch stem is 0. 5" diameter (will require roughly 1 2" hole). Most Yanmars have a slightly larger hole so you will just use a washer to make fit. THIS